Tap ADT P3500 compensator tap stainless steel 35mm for 7 + 10mm pipes

 Compensator tap ADT P3500 stainless steel for 7 & 10mm lines

Tap for 7 and 10mm lines

- Unique beer dispensing pleasure
- completely made of stainless steel
- with stainless steel compensator
- resistant to sugary drinks (draught beer)
- very good flow properties
- the flow rate can be adjusted by a lever on the side
- with foam button to put a foam crown on the beer
- self-closing (by taking out the front spring not self-closing)
- easy cleaning
- thread length 35mm

suitable cleaning adapter ---> cleaning adapter no. 2

Operating pressures between 1 bar and 3 bar (wheat beer) are nothing unusual for the compensator tap.

Prerequisite for the correct functioning of the tap is of course the setting of the correct operating pressure at the dispensing equipment.

If you do not have a table or slide rule to determine the correct operating pressure, the following rule of thumb applies:

Only when the beer stream runs "round" and clear (without bubbles) from the tap, the operating pressure is set correctly.

Ideally suited also for beer flow coolers and bar trucks where a fast beer tapping is required.

To cover the protruding thread length spacer sleeves are used which you can find here in chrome and brass:

Spacer sleeves for taps